loading test meaning in Hindi

Examples

1. After the assembly had passed loading tests, the individual girders were then tested to destruction.
2. The diagnosis is made by performing a saline suppression test, ambulatory salt loading test, or fludrocortisone suppression test.
3. In approximately half of cases, a phenylalanine loading test can be used to show decreased conversion from the amino acid phenylalanine to tyrosine.
4. The wall can be used to perform seismic tests by using experimental methods, such as traditional quasi-static tests, cyclic loading tests and pseudo-dynamic tests.
5. Loading tests with measurement trains on the open line, starting tests on the Berlin outer ring and other task were carried out by this special division of the Deutsche Reichsbahn.
6. Samples taken from the field are subjected to a variety of tests, like the constant rate of strain test ( CRS ) or the incremental loading test ( IL ).
7. While some tests indicate its strength lies somewhere between the weaker Bowline and stronger figure-of-eight loop, the trident loop shows exceptional resistance to slipping in shock-loading tests.
8. Ammonium chloride is used as a systemic acidifying agent in treatment of severe metabolic alkalosis, in oral acid loading test to diagnose distal renal tubular acidosis, to maintain the urine at an acid pH in the treatment of some urinary-tract disorders.
9. Sandbag loading tests revealed that the safety factor of the rear spar was less than that of the front, and a revised wing design with a deeper rear spar ( and consequently a different aerofoil section ) and equal-span wings was designed.
10. Han ( 2013 ) summarizes comprehensive research conducted at the University of Kansas including static and cyclic plate loading tests, full-scale moving wheel tests, and numerical modeling on geocell-reinforced base courses with different infill materials and discusses the main research findings from these studies regarding permanent, elastic, and creep deformations, stiffness, bearing capacity, and stress distribution, and the development of design methods for geocell-reinforced bases.